How to Use a Wood Lathe Machine For Beginners?

Wood lathe machine is a kind of CNC machine, which is specially used to process the rotating surface of wood or complex profiles. Wooden lathes are mainly used to process various staircase columns, Roman columns, table and chair legs, wash basins, wooden vases, wooden column tables, wooden sticks, wooden furniture, children's bed poles, etc. It can also handle plates, cups, bottle caps, wooden lids, lids, handles, sticks, flutes, flutes, cello accessories, etc.

CNC wood lathe machine are especially suitable for mass production of small and medium-sized woodworking companies. You can flexibly set the shape at any time and quickly change the rendering style. CNC wood lathes are usually equipped with two-axis, two-axis and three-axis CNC wood lathes, which can process two or three products of the same size and the same size at the same time. Simple operation, convenient drawing, easy to understand. Through one-click product style conversion, non-professionals can receive some training. The fully automatic CNC woodworking vehicle can run 2-3 units at the same time, which greatly improves the processing efficiency, saves labor, saves money, and brings good economic benefits.

CNC wood lathe machine should be inspected and maintained before and after use. The following are the specific maintenance rules: 1. Lubrication effect of the lathe In order to ensure the normal operation of the lathe, reduce wear and extend the service life, all friction parts of the lathe must be lubricated and lubricated. Pay attention to daily maintenance. 2. Oil pump lubrication-usually a large amount of lubricating oil is used in the high-speed continuous forced lubrication mechanism. This method is used for many lubrication points on the head. 3. There are many common lubrication methods for lathes. 

The most commonly used are: A. Cast oil lubrication: usually used for bare sliding surfaces, such as the slide rail surface of the bed rail surface. B. Splash lubrication-usually used in a closed box. For example, the rotating gear on the head of the lathe sprays the lower lubricating oil into the upper oil storage tank of the oil storage tank, and then flows through the oil holes in the oil storage tank to each lubrication point for lubrication. Pipeline: the usual oil pan in the sliding box of the feed box. 

The oil path easily absorbs oil and easily loses oil, and the oil is brought to the lubrication point through the oil path to intermittently drain the oil for lubrication. Reply. Billiard cutting oil filling and lubrication: usually used for tailstock bearings, skateboard rocker handles and tripod mounts (screws, light poles, control rods). Squeeze the nozzle at the end of the oil gun firmly and press the marble into the oil cup to fill the oil. After removing the lubricator, the marble returns to its original position. Seal oil to prevent dust from entering. Butter knife: usually used to replace the gear box, replace the shaft between the racks or where it is not suitable for frequent lubrication. Pre-pack calcium-based fat in a cup of butter. When lubrication is needed, tighten the oil cup cap again, and then squeeze the grease in the oil cup to the lubrication point. After the above maintenance, the CNC wood lathe machine can be more convenient to use and can extend its service life.