Publish Time: 2022-11-28 Origin: Site
1. Before starting the CNC woodworking router, the first thing to check is whether the circuit is in good condition, whether the voltage is stable or not, then check the machine’s power and operate the machine for some time before starting processing.
2. There are two kinds of spindles for the CNC woodworking router machine, one is the air-cooled spindle, the other is the water-cooled spindle. The main shaft of water cooling needs to keep the cleaning of cooling water and the normal operation of pumps. Here is a clear reminder: water cooling spindle motors must not be water deficient. Besides the above maintenance work, we should also pay attention to water temperature, and the cooling water temperature is too high, which will greatly reduce the cooling effect. It will cause some damage to the spindle, so it is necessary to replace the cooling water in time. In winter, we should also do some anti-freezing measures to prevent water pipes from cracking.
3. Regularly clean the heat and ventilation system of the carton engraving machine circuit box, check whether the fans are working normally, regularly clean the dust in the electric control box, and check whether the screw of the wiring terminal is loose, to ensure the safe and reliable use of the circuit.
4. Clean the rails and the sawdust in time and fill the transmission system in time.
5. Clean up dust and oil on the sensor in time.
6. After the CNC woodworking router machine has been processed, the bits are removed and the spindle chuck is relaxed. This will help to prolong the service life of the spindle chuck. Then we start to clean the workbench and use the brush to clean it. Pay attention to the work table. It is usually better not to pile up all kinds of debris, to avoid the deformation of the platform. Finally, we need to move the head to the lower left or lower right position to stop the collision. Then cut off the power.
7. If the CNC woodworking router machine is not used for a long time, it is better to turn on the blank line once a week to prevent the machine from being dampened, and to ensure that the electrical components of the equipment are stable and reliable.
8. It is best not to open the cabinet frequently. In the carving time and space, dust, sawdust or metal powder will usually be found. Once they fall into the circuit board or electronic device of the electronic control box, the insulation resistance of the components will be reduced, and even the components and circuit boards will be damaged.
9. Regularly check whether the bolts of various parts of the woodworkingworking engraving machine are loose.
10. Vacuum pump maintenance:
The water circulation air pump, the metal mesh in the suction port is used to prevent dust from entering, and the filter net should be kept clean at any time, to avoid the blockage and cause the pumping speed to drop. When the pump is not used, it should be energized for several minutes every week to prevent the rust of the pump body from functioning properly.
At the same time, the vacuum pump should also release the butterfly nut, take out the paper filter element regularly, and use high-pressure gas to clean the filter net. It is found that the filter core is not ventilated or damaged. It should be replaced in time.