Publish Time: 2022-03-05 Origin: Site
An Furniture Edge Banding Machine is a power tool that works by gluing and automatically feeding the edges of different types of materials to create a finished look. Edge bander creates an even, clean finish on the edges of wood or other materials that can be difficult to do by hand. The edge banding machine has a table of sorts that can be adjusted for height and angle, a clamp to hold the workpiece tightly in place while it’s being worked on, an adjustable-width glue roller, a conveyor belt that advances the workpiece into position, and a roller that applies pressure to hold things in place
1. You can judge by yourself and perform simple maintenance to save time and bring greater use benefits. The screw of the automatic edge banding machine is loose and the trimming is unstable. Find the benchmark, tighten the screw, and adjust the tool.
2. A problem in the pressing part leads to abnormal operation of the trimming and polishing equipment. If the plate is not pressed tightly, or there is a height before and after the pressing vertical plate, when the plate travels to the glued part, the rubber coating wheel and the pressing wheel exert a certain pressure on the side of the plate, causing the plate to shift away from the reference line, resulting in subsequent The process cannot be completed. Solution: Press the plate tightly, and the tightness of the front and back is the same, and then lean the reference ruler and the profiling wheel of the trimming tool on the plate, and adjust the tool to the desired effect.
3. The trimming datum plane of the automatic edge banding machine does not find the board surface. The trimming knife can accurately trim the edge band to the ideal line thanks to the horizontal and vertical leaning ruler beside the trimming knife. If they can't cling to the moving board, it is bound to be unable to repair proper lines. Solution: Send a long plate with a flat end surface into the edge banding machine. When the plate travels to a position that can cover polishing, scraping, finishing, and rough repair, stop the conveyor belt and use the plate surface as the reference
There are a few common problems may occur when using the Furniture Edge Banding Machine:
1. During using, the edgebanding is not sealed well. In some cases, the glue cannot be spread in a smooth, regular and equal way.
(1) The amount of glue may not be adjusted well. You can try to adjust the amount of glue.
(2) The glue pot has not been cleaned up in time
(3) You can check whether the heating tube under the glue pot is broken.
These three situations are the most common to occur.
2. The function of the head cleaning is not working. In this case, you can check whether it is a problem of pneumatic components and switch of control. In this situation, you need to adjust the machine under the guidance of professionals.
3. The edge banding machine stops working automatically after a period of time. In this case, if you have not mishandled, normally is the main power supply has a problem, you can ask an electrician to check the wiring problem.