Computer Controlled Wood Carving Machine

Computer controlled wood carving machine maintenance:

    If the water circulation vacuum pump is found to have insufficient suction and the sound of the motor becomes lighter, please stop immediately for inspection

    1. Patiently check whether the water level of the water tank is higher than two-thirds of the height of the vacuum pump head. If it is too low, please add water immediately.

    2. If the water level of the water tank is high enough, please check whether the inlet pipe between the pump heads of the water tank is blocked, resulting in insufficient water supply.

    3. After the equipment cleaning and water supplementation is completed, the air inlet must be plugged at the start of the equipment to control the air intake to let enough water flow into the pump body and generate enough vacuum degree.

    4. Please clean the water tank, inlet pipe and change the water within 150 days after using the vacuum pump.Please close the water inlet valve of the water tank and drain the water in the inlet pipe if it is not used in the short term.If not used for a long time, please completely prevent and control the water in the water pipe and pump head to prevent rust and affect the operation.

    5. It is not used for a long time. If it is found that the motor cannot operate after being energized, it is recommended to use pipe tongs to rotate the fan blade shaft after adding force, so that the rust point of the pump head will be loosened, and it can be used normally.

The wood carving engraving machine is the most difficult and widely used technology in the CNC technology center. It is mainly used in the efficient, precise and automatic processing of complex curved surfaces. Today IGOLDENCNC introduces the application advantages of five-axis CNC engraving machine.

Wood engraving cnc router advantages:

1. Accurate carving:

The cheap wood carving machine is controlled by the computer, and the computer is used for engraving. The layout of the computer is set to ensure the accuracy and error of each process.

2. Simple operation:

The central main control system of the CNC engraving machine is based on the imaging operating system to terminally issue engraving commands. This requires workers to put the material on the machine tool and then activate the switch.

3. Diverse patterns:

The CNC engraving machine can operate all kinds of complex engraving without difference.

4. Raw material saving:

The engraving machine data is accurate without errors, so it will not cause the loss of raw materials and reduce the cost.

Generally speaking, the CNC engraving machine has two characteristics. On the one hand, the engraving accuracy is high. The accuracy of some high-end CNC engraving machines can even reach the last two decimal places. In addition, using CNC Carving Machine can also know in advance what the finished product will look like. Therefore, CNC carving machine is a very important equipment in modern industry.